Tag Archives: spektrum

Beginners Guide to Installing a New Transmitter for Your Boat ….!!

It’s quite hard as a Beginner to deal with some of the barriers-to-entry of radio sailing and especially anything to do with the radio control kit. Most likely in life, you will not have encountered it before!

The first quite likely thing to happen, is that you buy a nice second hand boat and the radio kit does not come with it. You’re “out there” feeling exposed straight away !! However, you can come to the same first-timer problem from quite a few start points.

It’s not all that difficult to do, but the first time it will not feel all that easy either. Whenever you pick up the transmitter manuals, for radio sailing first timers they are no use at all.

There are a multiple of ways to do this, and essentially it is the same process for all brands of transmitter. The most common transmitter brand at our club is Futaba, and this is what I used for the two methods described in this document.

If you are experienced and have some suggestions or amendments to make, please DO send them in so we can include them in a future revision.

Radio Receiver Chatter – Interesting Short Video….!

I saw in the Club WhatsApp group some exchanges about transmitters and receivers. In particular, Craig and Rohan were very keen on a receiver unit called the AR620 from Spektrum.

This little video came up when I googled it. It’s just a few minutes long. It’s an interview with the Technical Director of Spektrum. It is pretty interesting to hear what the product designers think is important. Of course, it’s 100% about planes and rc cars, but nonetheless I was intrigued to hear his comments about:-

  • No antenna – integrated aerial by Texas Instruments and it actually performs better than dangly wire aerials
  • Binding to the transmitter via a button, and two methods
  • FlyBy telemetry for reading onboard battery capacity, and “flyby” means it only works to a range of 600-800 feet
  • A very intriguing set of remarks about mounting the receiver 2-3 inches away from carbon fibre in the plane fuselage as the carbon blocks the signal. Given the amount of carbon fibre in our Marbleheads, it’s worth reflecting over. Note that Craig and Rohan didn’t make any comments about this being a problem. A small (not thorough) piece of research from me said that Kevlar does let radio signals in. Interesting.
  • Quite a large amount of chat about two failsafe modes, “PreSet” and “SmartSafe” and the “Hold Last Command”. In radio sailing that part of worth listening to a couple of times.